Water Damage Drywall Repair in Gainesville, FL

Talk to a Drywall Specialist: (352) 649-3354
Collapsed water-damaged ceiling with wet insulation in a Gainesville, FL bathroom

A water-damaged drywall section in Gainesville costs $350 to $1,200 to cut out and repair in 2026. The price turns on size and how far the wet board runs. We check with a moisture meter before any price is set. The sidebar holds the live ranges.

Water Damage Drywall Repair Prices

Water Damage Drywall Repair Specs

Peeling plaster on a wall damaged by water in Gainesville, FL

How the work runs

First the leak must be fixed and stopped. Then we cut to dry board, dry the cavity, and patch. No wet board is sealed in. That rule keeps mold from growing back in the wall.

Common questions

Cost calculator

Pick a job and a size. The range updates from the same numbers in our cost guide.

Price ranges

Read the full cost guide

Call (352) 649-3354 for a free written quote.

Get a Free Estimate

Recent work

New tape lines over drywall joints below a coffered ceiling in a Gainesville, FL home
Crew setting a drywall ceiling panel into place in a Gainesville, FL home
Smoothing joint compound over a patched wall section in Gainesville, FL

Frequently Asked Questions

What does a section cost?

$350 to $1,200 per section based on size and spot.

Can you start before the leak is fixed?

No. The leak must be fixed first. New board over a live leak fails fast.

How do you know it is dry?

A moisture meter reads the studs and board edge. We close up only at a dry read.

Do you treat mold?

Small surface spots are cut out with the board. Big mold jobs go to a mold firm; we do the drywall after.

How long does it take?

Two to four days with dry time for most sections.

Is the check free?

Yes. The check and the firm price cost nothing.

What Does My Drywall Project Cost?

Drywall is priced by the square foot of wall and ceiling surface — not by the size of your floor. That one fact explains most of the gap between quotes. Use the calculator below for a planning range on your job.

Drywall Repair & Patch

Most single repairs land between $250 and $800. We price patches by the square foot of damaged area — roughly $55–$75 a foot — but every repair carries a minimum job charge, because a patch takes the same setup and the same repeat trips for drying coats whether it's the size of a dinner plate or a door. Grouping several spots into one visit is the cheapest way to fix them: they share one minimum. Some repairs are priced flat by the job instead of the square foot: a wet wall section cut out, dried, and replaced (a 4×8 section ran $820 flat), long seam cracks (five re-taped seams across two rooms ran $590 flat), and popcorn removal finished smooth (a 200 sq ft ceiling ran $520 flat).

New Drywall Installation

For bare studs finished paint-ready (a standard Level 4 finish), plan on $1.60–$3.05 per sq ft of wall and ceiling surface, materials and labor included. A typical 12×12 bedroom with 8-foot ceilings — that's 528 sq ft of surface — runs about $845–$1,610 around Gainesville.

Room Remodel & Replacement

Tearing out old drywall and hauling it off adds $0.60–$1.20 per sq ft on top of new installation — a combined $2.20–$4.25 per sq ft. That same 12×12 bedroom, gutted and re-drywalled, runs about $1,160–$2,245. Opening walls can uncover surprises — water damage, old wiring — and those get priced once they're visible, never guessed at in advance.

Garage Drywall

Garages run $1.55–$3.30 per sq ft depending on finish. Code requires 5/8-inch fire-rated (Type X) board on the wall shared with the house, and on the ceiling when there's living space above it — that's the fire separation, not an upsell. Most two-car garages land between $1,900 and $4,100 finished.

Texture, Skim & Paint

On walls that are already up: skim coating runs $0.95–$1.30 per sq ft, orange-peel or knockdown texture $0.80–$1.85, and primer plus two coats of paint $1.05–$2.80. A typical room's walls — about 415 sq ft of surface — usually land between $770 and $1,930 for texture and paint together.

What Moves the Price

  • Finish level. A full Level 5 skim coat (for gloss paint or bright, raking light) costs more than standard paint-ready Level 4.
  • Ceilings. Overhead work runs roughly 20–25% more than the same area on a wall — lifts, heavier board, two sets of hands.
  • Ceiling height. Taller walls mean longer sheets, scaffolding, and slower work.
  • Texture matching. Blending a patch into existing orange peel or knockdown is hand work, and it's priced like it.
  • Tear-out. Removing old drywall and disposing of it is its own line on the quote.
  • Job size. Small jobs carry a minimum charge; on big jobs the setup spreads over more feet, so the per-foot price drops.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

Estimate Your Project

1 · Pick your project
Your estimated range

Free — no obligation. Your calculator numbers ride along with the request.

📞 (352) 649-3354