Drywall Cost Guide for Gainesville, FL

Talk to a Drywall Specialist: (352) 649-3354
Applying joint compound around an opening in a wall in Gainesville, FL

This guide holds the ranges the rest of this site uses. Install: $2.00 to $3.50 per square foot, hung and finished. Taping and mudding alone: $1.00 to $2.00 per square foot. Texture match: add $0.75 to $1.50 per square foot. Popcorn removal: $1.50 to $3.00 per square foot. Patches: $250 to $900 per job. Water damage sections: $350 to $1,200 each. The guide is dated 2026 and built from Gainesville area bid data. Call (352) 649-3354 for a firm price on your room.

Unit prices

What moves the price

Area sets the base. Finish level adds coats and sand time. Ceiling height adds lift time. Texture adds a spray pass and a blend edge. Wet work adds cut-out, dry time, and new board. Each bid on this system lists these as lines.

Patch or full sheet?

A hole the size of a plate is a patch job. A wall with many holes or soft, wet board is a sheet job. If less than a third of the wall is hurt, a patch is most often the right buy. If the board is soft when pressed, new board costs less over time. We give both prices at the site check when both paths make sense.

A note on old ceilings

Many Gainesville homes built before 1980 have popcorn ceilings. Some of that texture holds asbestos. A test kit costs little and keeps the job safe. We will not scrape an old ceiling blind. The test fee, if you need one, shows at cost on the bid.

How to read a bid

A bid that hides these in one lump sum is hard to check. Ask for the lines. Any firm can split a bid if the math is real.

Next step

Try the calculator on the install page or the repair page. Then contact us for a free written bid.

Frequently Asked Questions

What is the unit price for new drywall?

$2.00 to $3.50 per square foot in 2026, hung and finished. Board, tape, mud, and sanding are in that range.

What adds the most cost?

Area first. Then finish level, ceiling height, and texture. Paint is priced apart in most bids.

How do I read a bid?

Each line should name the work and its price: board, hang, finish, texture. If a bid is one lump sum, ask for the lines.

What finish level do I need?

Level 4 is the norm for walls that get flat or eggshell paint. Level 5 is best under gloss paint or hard side light.

Do patches come with a firm price?

Yes, after the free check. Most patches are $250 to $900 based on size and texture work.

Which towns do you serve?

Gainesville and the towns around it — Newberry, Alachua, High Springs, Archer, Micanopy, and more. The service areas page lists every town we serve, and each town page shows its own ranges and facts.

What Does My Drywall Project Cost?

Drywall is priced by the square foot of wall and ceiling surface — not by the size of your floor. That one fact explains most of the gap between quotes. Use the calculator below for a planning range on your job.

Drywall Repair & Patch

Most single repairs land between $250 and $800. We price patches by the square foot of damaged area — roughly $55–$75 a foot — but every repair carries a minimum job charge, because a patch takes the same setup and the same repeat trips for drying coats whether it's the size of a dinner plate or a door. Grouping several spots into one visit is the cheapest way to fix them: they share one minimum. Some repairs are priced flat by the job instead of the square foot: a wet wall section cut out, dried, and replaced (a 4×8 section ran $820 flat), long seam cracks (five re-taped seams across two rooms ran $590 flat), and popcorn removal finished smooth (a 200 sq ft ceiling ran $520 flat).

New Drywall Installation

For bare studs finished paint-ready (a standard Level 4 finish), plan on $1.60–$3.05 per sq ft of wall and ceiling surface, materials and labor included. A typical 12×12 bedroom with 8-foot ceilings — that's 528 sq ft of surface — runs about $845–$1,610 around Gainesville.

Room Remodel & Replacement

Tearing out old drywall and hauling it off adds $0.60–$1.20 per sq ft on top of new installation — a combined $2.20–$4.25 per sq ft. That same 12×12 bedroom, gutted and re-drywalled, runs about $1,160–$2,245. Opening walls can uncover surprises — water damage, old wiring — and those get priced once they're visible, never guessed at in advance.

Garage Drywall

Garages run $1.55–$3.30 per sq ft depending on finish. Code requires 5/8-inch fire-rated (Type X) board on the wall shared with the house, and on the ceiling when there's living space above it — that's the fire separation, not an upsell. Most two-car garages land between $1,900 and $4,100 finished.

Texture, Skim & Paint

On walls that are already up: skim coating runs $0.95–$1.30 per sq ft, orange-peel or knockdown texture $0.80–$1.85, and primer plus two coats of paint $1.05–$2.80. A typical room's walls — about 415 sq ft of surface — usually land between $770 and $1,930 for texture and paint together.

What Moves the Price

  • Finish level. A full Level 5 skim coat (for gloss paint or bright, raking light) costs more than standard paint-ready Level 4.
  • Ceilings. Overhead work runs roughly 20–25% more than the same area on a wall — lifts, heavier board, two sets of hands.
  • Ceiling height. Taller walls mean longer sheets, scaffolding, and slower work.
  • Texture matching. Blending a patch into existing orange peel or knockdown is hand work, and it's priced like it.
  • Tear-out. Removing old drywall and disposing of it is its own line on the quote.
  • Job size. Small jobs carry a minimum charge; on big jobs the setup spreads over more feet, so the per-foot price drops.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

Estimate Your Project

1 · Pick your project
Your estimated range

Free — no obligation. Your calculator numbers ride along with the request.

📞 (352) 649-3354